Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature currently requires accessing the site using the built-in Safari browser.
Watch Out for Scammers!
We've now added a color code for all accounts. Orange accounts are new members, Blue are full members, and Green are Supporters. If you get a message about a sale from an orange account, make sure you pay attention before sending any money!
For sale is a Pierce Engineering action with XLR Evolution chassis Cerakoted burnt bark, Krieger 308 1/10 twist barrel, Shilen trigger. Barreled action is Cerakoted black, threaded by Pierce 5/8x24 with matching thread protector. The scope is a Gen 1 Vortex Razor 5-20 with mil/mil, mount is...
Took the Fix to Thunder Valley Precision for open range day a couple weeks back and it way outperformed my expectations. Hitting steel at a thousand became boring so I tried my luck at a mile. I took 15 shots or so between rain showers and came very close but never hit. Not bad for 10 pound...
If you're concerned about strength, the way I did it replaces a thin piece of rubber with hard plastic supported along most of it's length by the stock mechanism. If there is enough interest I will take mine back apart and make a step by step with better pictures. I should have done that in the...
Paint job turned out sharp! I'll be curious how the limbsaver holds up sans the added support from the stock adjustment mechanism. The plastic is fairly rigid, but flashbacks of rifles falling butt end first left me wanting to err on the side of more cross sectional area. Then again maybe the...
Just that the height has to be set to the middle or below because of the added width of the limbsaver. No big deal at all, I run it in the center normally anyways.
Worked out great! Sorry I have loctite on the fasteners but I will post all that I took on my phone the day I did it. Pretty simple, just had to open up the bottom square channel for the square nut. Let me know if there's anything specific I can take a photo of.
After swapping the stock pad for the limbsaver and swapping my scope/mount combo I was able to shoot my first sub .5" group with my Bartlein Tooley 6.5 barrel. The only thing holding the rifle back was that thin little pad that made it difficult to build up a position. Couldn't be happier with...
Buttpad itself just needs to be pulled/pushed out of the holder, mine did tear at the molded keepers but I wasn't going back. To remove the pad holder assembly you just adjust the pad full up and remove the screw and full down, and remove the screw.
Well I had vacation this week and the deer hunting has been slow so I decided to get after the butt pad issue. I took the butt pad assembly off and after removing the thin rubber torture device, noticed that the holes in the pad holder matched up almost perfectly with a limbsaver I had lying...
I stand by what I said that for ME iit could replace all of my BOLT ACTION rifles, and I would add the caveat of centerfire to that. Browning X Bolt Western Hunter 6.5 Creedmoor- The Fix is about a pound heavier, but the folding stock helps with ease of carry. I see no reason that the Fix...
Just for the opportunity to shoot the Fix out to 1000 I shot a local F-Class match this weekend. I got some funny looks with my whole setup weighing less than most other shooters barrels, but the rifle performed great. Taking the muzzle brake off (required for high power matches) and firing 80...