Looks like the 30BR project is gonna happen after all.
All that's still needed is the brass, and I'm looking hard at ordering Lapua 6mmBR brass sometime over the next few weeks. Everything else, including the necessary widgets to neck up and prep the brass is already onhand.
I'm wondering if anybody else here is shooting this chambering (besides JDA, Sr), and what data they've been using with success. Assume a barrel length of around 23" and a target distance at 200-250yd.
I already have load data for the 125gr Speer TNT, a good stock of HDY 110 V-Max, and several hundred SRA 125gr Flat Base SMK's on order.
The initial powder of choice is IMR-4198, and I am also running a parallel load developement project using the 7.62(.308 Diameter)x39.
Greg
All that's still needed is the brass, and I'm looking hard at ordering Lapua 6mmBR brass sometime over the next few weeks. Everything else, including the necessary widgets to neck up and prep the brass is already onhand.
I'm wondering if anybody else here is shooting this chambering (besides JDA, Sr), and what data they've been using with success. Assume a barrel length of around 23" and a target distance at 200-250yd.
I already have load data for the 125gr Speer TNT, a good stock of HDY 110 V-Max, and several hundred SRA 125gr Flat Base SMK's on order.
The initial powder of choice is IMR-4198, and I am also running a parallel load developement project using the 7.62(.308 Diameter)x39.
Greg