Gunsmithing Source for quality "Kryptek" knock-off stencils?

[Wannashootit]

I've been buying the "real deal" from MCM, and the quality of the stencil/ red vinyl is second to none...but $20 per 11" sheet ($50 per rifle shipped) is really eating into the profits....I realize everyone needs to make a few bucks- but it's only vinyl (BTW- Cerakote, so it has to withstand the bake cycles like the yellow Avery 100-235-S)

I've used an Ebay knock-off, but the release paper was shit- and it's critical with an intricate stencil like this that it "work" perfectly.

Anyone have a trusted vendor for a Kryptek "style" stencil that won't break the bank?

 

[...]

might come out a touch cheaper......but montactical also has them

https://www.montactical.com/product/hextech-camouflage-stencil-kit/


have you thought about buying a vinyl cutter?.......if youre doing significant volumes, it might be worth in investment.

 

[Wannashootit]

^^^
No transfer paper on their stencil. That's NUTS. Weeding a pattern as complex as this piece by piece? Insanity...It would take all day, the borders would look like dogshit.

 

[LRI]

I have them. Single use only. I would advise you to find an RC airplane hobby shop in your area. Buy a heat gun specific for applying Duracote wing covering. They aren't too bad, $15-$40 bucks. You want this as the vinyl molds and "bites" the surface much better. My stencils are a medium tack adhesive. They'll lay out great on flat surfaces but experience has shown you get a better result if you heat them up slightly when wrapping around grips and tight corners.

Made in house. Happy to help. $40.00+shipping.