Login to view embedded media
holy shit...

A middle school in New York and its food vendor, Aramark, apologized after students were served chicken and waffles, along with watermelon on the first day of Black History Month.


The lunch menu offered on February 1 at Nyack Middle School in Rockland County was “inexcusably insensitive and reflected a lack of understanding of our district’s vision to address racial bias,” David A. Johnson, the school’s principal, wrote in a letter to parents.

Click to expand...

Wondering if anyone has had trigger time behind both optics and could provide any comparisons of the two?

I've been running a 4-32 (MIL-C) in NRL22 for a while. I've looked though a 5-27 (MPCT3) and loved the larger sight picture. The weight and size does concern me a bit, but I'm thinking a 4-20 could have some advantages to a 5-27 and the 4-32.

I'd also be looking to run it for bench shooting at primarily 100y and steel from 100-300y (not sure how well a 4-20 would fair shooting small bore to 300y though).

Thanks in advance!

"High BC bullets might be important for long-range shooting, but they’re not the only thing that matters. Velocity—just as it always has been and always will be—is important, too. For example, 6.5 Creedmoor is generally touted as being a better long-range cartridge than the .260 Rem., even though the .260 Rem. has more powder capacity and can push bullets faster. The reason for this is that factory rifles for the Creedmoor are built with a 1:8-inch twist as opposed to the 1:9-inch rifling twist of the .260. Because of this, factory Creedmoor ammo can be loaded with higher BC bullets."

And the entire article..... https://www.shootingillustrated.com...l&utm_campaign=020223email&utm_id=020223email

How much cash would be appropiate to have on hand for an emergency fund?
House, cars are all paid for and no debt.
What about your SHTF go bag cash?
Just that

Can anyone tell me if the 125gr. Laser- Tipped Hollow Point is single feed only

selling my used white mdt acc Remington 700 SA footprint. Comes with folding buttstock adapter full internal weights new grip cheek piece rear weight and bag rider
$1050 shipped insured

So high points - a 13 year career keeping the streets of AZ safe . Then 61 criminal counts including rape and kidnapping.
5 year sentence. Sounds legit.

Wiebad cheek pad- 35$

Sac two rd holder- 15$

Area 419 thread protector with adapter 5/8x24- 25$

Cole take data card bungee- 15$

You pay shipping. Thanks

NX8 – 1-8x24mm F1 Capped, 1500 with mount 1350 without shipped. Glass is perfect Mil/Mil.​

Funding NV

Trades looking

B.E. MEYERS MAWL-C1+ IR / VISIBLE LASER + cash on my end. Wilcox G24 + cash on your end

Have an Atlas LW17 bipod with original ADM QD mount and Area 419 arca lock mount installed. Great shape $285 shipped

Most of the items are sold. I am keeping the rest.




I have 4 used San Tan Tactical receiver sets for sale. All of them have been assembled and had less than 250 rounds each through them. All of them have PWS buffer tubes with QD end plate and ratchet castle nut. 2 of the receivers have been engraved with my Trust info with the intent of SBRing them. That was never done and they have never been stamped. Both engravings are very hard to see and can't even notice them unless you know where to look.

I parted out 4 rifles and cleaned out the safe to make room and slim down the collection of parts. If you see anything in the pictures that I have not mentioned or listed. Feel free to ask about it.

$450 shipped STT-15
$425 shipped STT-15L
$400 each shipped STT-15L (engraved)
$275 each Surefire M600DF x3
SOLD $50 each Streamlight TLR-1 x5
SODL $75 Unity Mod Button Pic switch x2
SOLD $100 Unity Tactical Hot button Mlok switch
$~ Mlok scout light mount (multiple options)
$220 $200 Geissele SSA-E x3
$250 Geissele MK4 10.5"
$275 Geissele MK4 13.5"
$275 Geissele MK16 15"
$325 Geissele MK18 16"
SOLD $350 Daniel Defense DDM4 12"
SOLD $75 each Geissele Super Charging Handle x2
$180 Rubber City Armory BCG AR-15 556 x3
SOLD $115 JP Silent Captured Spring reg x2
SOLD $125 JP Silent Captured Spring heavy
SOLD $65 SBA3 w/strap
SOLD $50 BCM sock
$40 each BCM low pro gas block x1
SOLD $100 SLR Adjustable gas block
$600 Bartlein Craddock Precision 18" SPR/MK12 223 wylde 1/7.5 twist, rifle length

I've had two Faxon Match barrels so far. I have not been impressed from the get-go. These barrels come in a shitty plastic sleeve with zero padding, my latest one was halfway protruding out of the cardboard box OpticsPlanet sent it in.

The first one was a Heavy Fluted Match 18", I was actually decently impressed with how it handled 55gr stuff - shooting cheapo XTAC ammo at a consistent 1.8-2.2 MOA. Unfortunately, on the other side of the coin SMK tipped ammo like IMI/AAC couldn't push past 1.5 MOA. I sold it and instead bought their:

Gunner Match 18", this one is way worse. Shooting a solid 2.0 MOA with SMK tipped ammo, slinging 55gr stuff at about 3.0-4.0 MOA.


I've tried

• IMI 77gr SMKs
• PMC XTAC 55gr
• Fiocchi 62gr BTFMJ
• Frontier 68 & 75gr OTM
• AAC 77gr SMKs and 75gr OTM

These are all loads that grouped well in my old Criterion barrel.

I see a lot of raving reviews on Faxon's review pages - 5 star across the board. Everyone saying their barrels shoot excellently. But I'm 2/2 for barrels that simply do not perform.

I am shooting off bags, with a 10x optic and no wind. I am allowing the barrel to cool for 15 minutes between groups, in 30-40f weather.

I have checked witness marks on my scope, my barrel nut, and my muzzle device. Both barrels were thermally fit into a BCM upper.

For the record, here's the best group I ever shot with my old Criterion, using factory IMI ammo. 5 shots in there.

Do I bother dealing with Faxon's swamped CS and hope #3 is better? Or do I just return to opticsplanet (if they even accept the return).



Thanks

Selling my Razor Gen III 6-36 EBR-7D.

Scope has not left my basement, overall looks almost brand new. Scope will come with a MPA 1 Piece Mount (O MOA) with the Pic Rail from MPA on the Front Scope Ring

Asking $2650 for Everything Pictured. Shipped Lower 48 (I don't have the original box with it)

Don't want to separate either.

1st "I'll Take it" in the comments trumps Private message

I always load conservatively and probably always will. It’s probably why I’ve never owned a 6.5cm that pushes a 140 at 2800 or a 308 that pushes a 175 at the same speed. Moving on.

Do you guys consider a faint ejector mark as a sign of pressure? I mean so slight that you have to get the angle right with the light to just barely see it? I’m not talking a swipe or an indention. Just an ever so slight shadow without any primer crater or anything of that nature.

Hello everyone!

New reloader and I cleaned my brass by hand shaking it in a plastic jug filled with about 75% water 25% white vinegar, baking soda and a bit of dish soap and hand shaking it for about 15mins and then after rinsing them really good and getting the water out of the inside of the case (mostly) putting them in the over @350 for about 20mins to dry.

I didn't notice any blue in the water which I know is a sign of the vinegar leeching the zinc out of the brass but when I pulled them out of the over they kind of have a rainbow hue to them.


do you think they are ruined?

Withdrawn.

If you are thinking of messaging with anything less than full value for either the entire package or individual items don't bother messaging. Spare me offers of like 8k for the complete AXSR kit, or 2k for the Raptar. You might think there is blood in the water, think again. I don't have to liquidate this. The last pic is just that, IYKYK, it is worth more than 75 flips.

This is dusty because it just came back from the range. It will be cleaned up. Everything is in excellent condition.

I bought this in January from a hide member. Only shot the 6.5 barrel on this rig.

Black AXSR in Pelican Storm 3200 case w/ Lapua Mag Bolt, Standard Mag (Win Mag) bolt, and Standard Bolt. Has competition trigger.

TS Customs 26" 6.5 Creed 1-8 twist barrel - 260 rounds fired

AINA 27" 300N barrel 1-8 twist - 80 rounds fired

1 Lapua Mag, 1 Win Mag Mag, 2 standard (308) mags.

MDT Single Pull Cyke Pod

AXSR Kit - 10K

ZCO 4-20 in Spuhr 6002 3.5K

Eotech CLIP-IR ELR w/ remote 14K

Unlocked Full Power Wilcox RAPTAR from SH group buy unlocked by Felipe w/ remote 6K https://www.snipershide.com/shooting/threads/wilcox-raptar-fp.7152087/

You can buy them individually or save 6K and get it as a package.

$27000 as a package. Shipped USPS Priority Mail.

Zelle or bank wire only.

Not for sale.

Giruad Trimmer heads and blades

Only 1 left:
260rem

30.

Please no paypal

I have a Sentry Safe, as seen in the attachment, and have not been pleased with it. It's rare that it opens on the first time and we all know if the situation arises where you need your HD pistol it's a life or death situation. Do you guys have any you suggest that the biometric part has opened without fail on the first try?

Bought this a few months ago . Used it for apx. 300 6.5 creedmoor cases(works perfectly). This include The cutter head for 223 as well as a case bin / brass shield . Everything needed for 6.5 & 223 . The 223 cutter head is brand new and has never been installed. Here my reciept.
$725 shipped for everything in the factory box .

Hate to sell it, can make a whole turnkey ready to go prs rig. Only selling because it sits in the safe and never gets appreciated like it should.
GAP Tempest action
Bartlein 26” barrel 280 round count
lil bastard muzzle brake
Manners folding stock
Two mags
Trigger tech diamond trigger
Will come with 100 once fired gap (Hornady) brass, 100 brand new brass, 100 110gr A-tips and 100 Berger 105gr hybrids
4k obo

Giraud Case Trimmer. Used 1 time. Don’t shoot enough to justify keeping it. $485 shipped. Located in Middle Tennessee 37064. Text or call for questions 615-866-8036
Comes with what’s in the pics.

Krieger 6mm blank for sale
M24 contour.

360 tyd.
Thanks PayPal f&f

Would binoculars, spotting scope or a kestrel be more useful for making hits at longer ranges? I’ve got about 1k to spend on one of the three. Help me out!