I have a brand new MDT Comp Brake in 308 - 5/8x24 thread pitch I want to rehome.
150 Shipped OBO

just testing the waters in this pretty much new build. LMT ambi lower, Geissele SSAE trigger, b5 sopmod, A5 length buffer tube with Geissele super42 rifle length buffer. Upper is a square forged upper, BRT m16 chrome bcg, PRI gas buster CH, Hodge 13.65” S-Lok handguard, SOLGW 16” SPR barrel. Thing shoots super soft and has only 80 rounds down it.

I also have a noveske 14.5” barrel with gas system and headspaced bolt that will come with it. Less than 100rds down it total.

I’m only selling because I really want an mk12 mod0.

Priced at $1800 but would trade the upper and both barrels for an mk12 upper as well

Selling this Mr. Bullet Feeder. Used a few times, works perfectly. Has everything for 9mm and 5.56/.223. $275 shipped. PayPal F&F or you pay the fee. Other forms of payment are good to go also.

Looking for a ZCO 420 10 mil NLE again.
M3x, M2x, M1x reticles in that order.

Hello, I used a Sinclair chamber gauge twice on my Steyr THB in .308 and had an average of 2.045". The trim recommendation for .308 is 2.015" so my question is at what point should I trim the case since there is a .03 gap? I also plan to chamber a FL sized empty brass and use my Teslong from the muzzle to verify the gap.

I purchased this rifle new, and it was an excellent setup for my dive into NRL22. I had RimX built a few months back, and don't see this getting any more use. Just add a scope and rings of your choice, and it is ready to go. This rifle has NEVER seen any copper-plated bullets and was fed SK Long Range Match, which it shot very well. It is in very good condition and was well taken care of.

Tikka T1x 22LR MTR 20" barrel, 16 twist, threaded 1/2-28 with factory plastic cap (this piece shows a bit of wear)
I replaced the bolt handle, and now it accepts standard 5/16-24 knobs (I believe it's from Anarchy Outdoors)
KRG Bravo (Sako Green) w/ what I believe is all the original accessories (LOP spacers, bolts, pic rail, bipod stud)
Bag rider
MDT 40 MOA rail
Mountain Tactical Trigger Spring
Rusty Nuts Designs Flat Trigger (currently set at 10 ounces)
2 Factory 10-round magazine
1 15-round NDR magazine
Factory magazine pouch

I have approximately $1400 in it and am looking to get $900 shipped (OBO) to your FFL from an individual. I can also ship from an FFL if that is preferred. Reach out with any questions, and I am also available to talk on the phone if desired. Preferred payment is PPFF, but others can be discussed.

XLR element 3.0 Short action R700 ambi, AL version not mg.
Comes with the henderson arca rail, ergo grip, and TR-2 butt stock. What you see in the photos if what you get. $450 shipped to the lower 48. Paypal F/F or Zelle

Used it for practice and on my NRL hunter gun made weight easily with a light steel barrel. Ended up getting a lighter barrel so going with my envy pro instead for hunter. Some scuffs and marks from just general use. Let me know if you have any questions.

Login to view embedded media
The next chapter in the false DUI arrest for profit scandal. Even though TN pulled the incentives for DUI arrests this guy has kept at it - his eighth arrest of a sober person for DUI. He said in his statement that being completely innocent is no defense against arrest .
This guy is a hustler and he’s going places I see a command post in his future.

I bought this for a local gunsmith before I started shooting for a team, so I no longer need it. It is new. IDK what all info I need to give off the reamer but will be happy to answer any questions I can. Asking $150 shipped

11lbs 10.5 ounces
Now if I can just get my work schedule to cooperate with the NRL Hunter schedule:

Glock 43X MOS

• tactical pontoon atom trigger
• Dawson sights -Blacked out rear, red finer front
• EPS Carry Red 6 moa with box
• vedder light tuck holster, claw included
• alien multi use light bearing holster
• 2 PSA 15 rounf mags that run flawlessly
• 2 oem 10 round mags

$750
View attachment IMG_7460.jpeg

Hey guys.. I am relatively new to the powder world.. Been playing with high power air guns last couple years and now stepping into long range as my 22 Air Rifle is good to 200-300 yards sub MOA but wanted to stretch to 1000 yards so got this baby in 6.5 Creedmore. Apparently 7-800 rounds through her.

Before anyone says throw out the bore scope I completely agree.. I got it to check on cleaning and just do a "safety" inspection before firing etc.

Let me know if anyone sees anything of concern.. I thnk all good.. Just needs a good cleaning.
Pic order is about 1" from lands into barrell.. Start of Lands and then the famous "carbon ring" area

Mike

Mags are $95 ea shipped. These mags are stamped KAC on the front, No stamping or 1S002 on the bottom, earlier. Bore guide is $45 shipped

Great condition Sig Kilo 10k-ABS 10x42 LRF binos. Used over the last year - no scratches on the lenses. Has all the factory gear and box included.

Asking $1300 shipped obo.

I already have an Accuracy International AT, which I converted into a PRS competition rifle. But now I want to buy or build a new bolt action rifle (Military style appearance）. I checked Sako， Mrad， they are all overpriced. Can anyone give me some advice? My budget is in 2500$, NOT including scope.

Cheap thrills here. Jack Mason "Seatrek" 300M diver. I believe this is discontinued. Cool look IMO. Miyota Quartz movement. AR crystal. 22mm lugs, 44mm case. Great shape and great lume. Nice affordable diver. Crazy firm ratcheting ET bezel. Not loose like a cheapo and the pip lines up dead on 12:00. Comes as shown. The thick gray leather strap is 125mm x 80mm. Will fit a med to large wrist no problem on this case. $200 shipped

Just bought a really early Brea USO 3.8-22 front parallax USO scope... It's in Mils (But marked 1click = 1cm at 100Meters, which is a really, really early USO marking for mils. Before folks were even calling Mils... Mils.)

This has a Horus reticle that is gradiated out to 4,000 meters!!! Crazy! The 100 meter 'sight in' position is so far up in the scope that there is barely any field of view above it (that is at 22 power... it's a bit better at 10x). But 4,000 meters on a Horus? What was this being set up for c. 2001 - 2004 or so? Only thing I can think of is a McMillan TAC 50 or an M82 Barrett? Maybe a Cheytac?

This is going to go on a structured barrel .300 Norma Magnum... so the reticle is actually useful in a modern sense.

But what on earth was Horus or JBW2 Thinking 20+ years ago when they created this scope? I can't think of anything then 'except' maybe a .408 Cheytac, a BMG or a couple of outliers like a 20mm Anzio?

Inquiring minds want to know! Anyone got any ideas?

Cheers,

Sirhr

I have a lightly used Accuracy International AXMC/AXSA 16” M-LOK forend tube with integrated RRS rail and 20 MOA top rail for sale. Elite Sand color.

Price: $425 shipped (not including HI and AK)

No Trades

Open to different payment options.

Looking for a AXSA not picky on caliber

Mark 5
5-25x56 PR1 moa reticle
Hawkins tactical rings

1700 shipped and insured

Does anyone have a source on viewing LR bullets at distance just before they hit the target? I searched all over youtube with no luck, plenty of videos with bullets leaving the barrel, shooting watermelons etc. But nothing from profile (side) view on LR bullets at distance - say 500/1000 yards.

What i'm looking for is:
1. The angle of the projectile
2. Specifically what stuff like polymer tips look like and if the factory claims are true.
3. Would love to see it on FLIR to pick up the heat signature as well.

Anyone have a resource like this? As i said, i searched all of YT and unless i'm not using the right terms... no can findo.

Giraud case trimmer Includes case holders and cutter heads for .6CM, 6BRDX, and additional cutter. Looking to get $525 shipped

Used Seekins Element. The third bullet out of this thing smoked an Elk at 550 yards. I put another 137 rounds through it in total. I have shot as far as 1558 on several occasions. The accuracy is unbelievable for a guy that has very little long range experience. This gun has made me an addict that's for sure. This has been my favorite gun of all time which is why im selling it. I really want the new Hunter Element with that folding chassis.
The goal is to sell the gun, not the other items. But if you want the gun and its addition's, the prices are below.

Gun alone: $2100
Plus NF, NX8 4-32x50 Mil-XT: $3800
Plus, ACCU-TAC PC-5 BIPOD BLk: $4100
Plus Pelican gun case: $4300

Per Newsmax, The DOJ is pushing directives, perhaps legislation, that would restrict the sale/possession etc. etc. of guns to those who are "Gender dysphoric." That is, they identify as transgender. This, after the last two violence incidents where the assailants identified as Transgender and committed the crimes, at least in part, based on that identity.

Thoughts? I have my own, but I'll get y'all's take on it first.

Edit: It's the DOJ that's spearheading the effort... not Pres. Trump directly.

I have a Primal Rights CPS with factory tubes with the small and large rifle rams. Will include a full set of Lee Shell Holders for it also.
Looking to get $600 shipped.