Horus 2000hovr rangefinder with Bluetooth and built in tripod adaptor new in box. $145 shipped and insured

Very lightly used FoxPro Hammerjack two and carry case.

$200 150 shipped conus. In the interest of economy I may break down the cardboard box for shipment unless seller objects.

I can take zelle, paypal f&f, or check.

Not interested in trades. Cross-posted so first time-stamped "I'll take it" wins.

This mag is brand new. I got it in, opened it, and realized it was the medium one (not for SA). $60 shipped or trade for an AICS 308 mag or wsm mag

Purchased this optic in October 2023 so just under 4 years left on the warranty.

Works exactly as it should. I bought this one as a backup/ optic for my sons. Didn’t get used enough to justify the cost.

$6900 obo you pay any shipping/insurance

Like new GAP-10 .308. Has the Hogan receivers that lock up nice and tight. I bought it used, so actual round count is unknown, but based on the wear on the bolt and carrier, it doesn’t have more than a few rounds down the barrel. Adjustable gas block. Will come with the Surefire suppressor mount/brake. Spuhr and S&B are available for $2700 more. Bipod and suppressor not included.

Trades considered….
Foundation or Manners stocks for Impact 737/rem 700 actions
Impact 737 AW cut
SB PMII scopes
Thermal scope or clip on
AMP annealer
Autotrickler
Bix and Andy trigger
Anschutz model 54 or Match/Super Match 22LR

New in the box with transferable unconditional lifetime warranty Vortex Diamondback Hd 8x32 binos and also included new no box just carry case vortex crossfire 1400 rangefinder

Bought for son he hasn’t used

$350 to door

I have the Sartorius Entris 64-1S scale with The Ingenuity Trickler system. It works great. However, recently I started noticing my scale takes several minutes to stabilize once I turn it on. And then after using it and verifying after have loaded some cases it has changed again. Small amounts of drift such as 0.026 to 0.050 or so. About a kernel or so of weight drift. It's not much but up to now it has taken very little time to stabilize and then rarely moved after was tared. I don't have anything like a line conditioner or antistatic mat etc. Just plug in and go.
Any ideas what is happening? Do I need to change my setup such as line conditioner, surge protector etc? It is always been in a separate room in my house with climate control. I have changed nothing. Never did anything to scale either. Thanks for the help!

My new brass has .312 necks. I typically size to .314. Loaded round is .317

Would loading right into the new cases without resizing the necks be a terrible idea? 5 thou seems like a lot.

Looking to buy a barreled action. Origin,cash or similar with available profits. I’m also interested in just an action . Preferred caliber would be 6gt 6dasher or 6creed let me know what you got

For sale is my safe queen NF ATACR 7-35 SFP with MOAR-T reticle. I have maybe fired 75 rounds of 6.5 CM with this scope. Has the faintest ring marks if looking for them but otherwise not a mark on it. Comes with everything as new except for the original box. Will come in a different NF box.

$2500 shipped OBO

YerrowSniper Estate In google sheet

Hello everyone I am Yerrowsniper brother. I am responsible for his gun estate. I wanted to reach out to this community, as i believe a lot of you might be interested in some of his items We hope that someone will appreciate his items as much as we do.

1) How can I get a price? Please go to the web sheet and email me back the tab, row, and quantity. I will therefore be able to give you a price and we can meet in metro Atlanta
2) What's your contact?: [email protected]
3) Using a phone that's too small? email me and I'll send you a list
4) Green is sold, red is on hold, and yellow has been considered but not finalized.
5) There are a total of 7 tabs.
5)NFA items. we wanted to do this later our lawyers said they would get back to us
7) I know that a Vortex HD Gen 2 will not fetch $3000 but because I am a one-man show, I needed a way to streamline this process. In general, people have been telling me what they are interested in; I put it into a tab on "sold/ongoing" and discounted it from there.
8) Primers and powder. I would like to deal with this locally for now. We live in Georgia.
9) YerrowSniper Estate In google sheet
10) detailed pictured on each row. more upon request

Thank you for looking at my brother's PRC items.

New Foundation Samson with centurion grip in Black inlet for Impact and Hawkins bottom metal which is included with brass weights. Sold shipped

I just got my hands on a pair of new Ruger Bisley Blackhawk convertibles 5.5" barrels in both 45 Colt/45 ACP and 357/9mm. The Berrys .452 plated hybrid hollow points ran great in the 45 ACP cylinder and I was just wondering if I use the oversize for caliber and brass .357 plated in 9mm cases it would also increase accuracy with the larger bore diameter, instead of like jacketed .355 normal pills. I am looking at the Berrys 148 gr plated hollow base wadcutter in .357. for 9mm cylinder. Also any load suggestions or advise for that, or these combo of revolvers if you're familiar with it. I'm just getting ramped up for revolver loading. Thanks!

For Sale: GAP-15 Rifle
Purchased from GA Precision
22” Bartlein Barrel 1:7.5 with 5/8x24 threads
Round Count: 220 (exactly)

Rifle is in pristine condition

PM me for more details

$2,200.00 shipped

from the Live Free or Die State!
New to precision long range shooting but a longtime gun owner and active on the range. I joined mostly to learn, but to also engage with members to discuss anything from politics, to best cartridge for xyz, to deep-dives on ballistics. Eager to jump in the deep end!
Cheers,
Michael

Berger 215gr 30 cal Hybrid Target. 2 unopened boxes of 100 and one opened with 98. All the same lot.

$70.00 shipped per 100 or $200.00 for all 3

OK , where have we settled on the 175 gr Eldx,s in 7mm PRC ? For me 68.5 of H1000 is a 2950 ft/sec 1 MOA or better . Its a 3.3 COAL , in ADG with VOLUMES around 81.55 gr of water . Anybody got another load that works too ?
cheers
les

Swarovski SLC 10x42 asking $1100
They are in great condition. Only thing not perfect is a slight mark on right objective you can see in the perfect light but is 100% not Perceivable when looking through binos.

I'm just curious and asking from folks experienced with ATN thermal scopes. I don't own any but curious about the quality and workmanship now.

Years ago, I didn't want to buy ATN because of the mixed reviews and many, many complaints about customer service. My experience with Chinese manufactured thermals is with the Burris line.

Even though many would criticize people like me for buying stuff made in China, realize that most of the USA made optics are priced way in the stratosphere. I do buy US made products but when it's something that is unobtanium from US businesses, we have no choice but to buy from overseas companies.

One thing that I was amazed to learn was that, according to ATN's website, their thermal scopes list USA as the "country of origin."

Now that probably means that parts are made overseas and some manufacturing processes are done here in the states. ATN isn't the only company that does that. Besides, almost 99% of the glass, IIRC, is ground in China.

I say all of this because I don't want to get into the "cheap Chinese POS" debate.

What I am curious about is the quality of ATN products now versus several years ago. I remember seeing reviews that were all over the map. There were just not enough good reviews to justify spending four figures on a thermal that had a good chance of breaking down and almost now chance of getting repaired.

I am seeing better reviews on the ATN thermal scopes now; which makes me curious.

Are the ATN scopes better than they were several years ago and has their customer service improved?

Does anyone know why the logo rings are special. I had someone that wanted them specifically a while back. Cloner boner stuff?

These are heavy I guess steel instead of ultra light

Vortex Switchback Carbon tripod with ball head. Used but in great condition

$SOLD

Garmin Tactix 7 Solar

Pro Ballistics version with Applied Ballistics

I’ve worn this shooting a few times

Really nice to use for range and target cards vs the kestrel which seems harder to read

I don’t really wear watches so it’s been a device I only wear at the big range, hence the good condition

Comes with 2 different bands and charging cord
Sold shipped

Anyone know if surefire will do a potential small batch of these if there was enough interest like they have done with the FA762SS?

For Sale NEW Unfired Surefire FA762SS And Brake On form 4 In OHIO! $ 5500.00

Does anyone here have experience with the Ops Inc style collar system?

I'm putting together a Gordon-type, and I wanted to run this BOM by someone before I start accumulating parts:

H&R C7 Upper Black
Criterion HYBRID 12.5" Barrel
Non-F marked FSB, .750"
OPS INC™ MK12 MOD ? SPR Collar... long or short? Is it just aesthetic? I think short.
Ops Inc Brake - LONG (AE just dropped a helpful video on this and I prefer shims to time)

I want it to be setup like the 9-hole Reviews Gordon vs clone correct with the 3 piece collar... and even though I'm using the lightweight OCM5, I'm not sensitive to barrel weight and prefer a more rigid, heavier barrel for anything that gets a suppressor on the end.



I think the collar requires .750, and the Criterion has that at the gas block... but it steps down slightly- is this a NO GO?




TIA for anyone who can help steer me in the right direction!