Search results

I am going to buy an Aimpoint ML2 and wanted to know what a good mount would be to have a cowitness for my BUIS. Any advice is appreciated. -Taylor

Re: Good Guy List Slacked on this a bit but NNTX Leadslinger both G2G

Re: Gayest thing I have ever seen... <div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: c_bass16</div><div class="ubbcode-body"><div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: taseal</div><div class="ubbcode-body">This is as gay as half...

Re: Good Guy List NNTX is g2g real smooth transaction

Re: 9mm loading question thanks guys

Re: 9mm loading question these are jacketed 124 grain flat points

I have always shot .355 diameter bullets but came across a good deal on some listed as .356; will this work for 9x19 (luger) reloading? Thanks Taylor

Getting ready to buy my first safe, have no idea whats good and what isn't. Just curious what you guys have to say about it. I have 19 rifles and 9 pistols and growing. Not worried about a fire just theft. Thanks, Taylor

Well my buddy and I were shooting today and he shot a round out of a glock .40, and the next round didnt chamber, upon inspection there was the casing for the previous round with no rim. Additionally, the case had shortened by half its original length! I had no answer as to what happened and...

Re: brass prep question thanks again to all who responded, Vic, I think im just going to start PM'ing you with everything, you have all the answers to almost every post ive made, haha Thanks again, Taylor

Re: brass prep question I wasnt actually trying to anneal it in this manner I just wanted to know if it would degrade the intergrity of the brass, thanks to both of you though. -Taylor

I have heard of people washing brass after coming out of tumbler with hot water and dawn. After washing them they place them in an oven to dry off- heres the question: I have recently been trying to learn about annealing brass and have read that over heating the brass will cause the case to...

Is there a proper way to install a base? Should I lube the base screws? And should I lube in between the rifle and the base? Any advice is appreciated. -Taylor

Re: Gotta share this one....For XL650 Owners Just bought one last week and had the same damn problem, was so pissed off I almost tried to sell the machine, i tried the detent spring trimming and it worked flawlessly, this was the back up plan. You may try to trim a full coil off the shell...

Re: Dillon 650 question/issue thanks guys, really appreciate the advice, I will update after trying a few of these.

Re: Dillon 650 question/issue you are the MAN!!!! Seriously thats awesome, thank you

I dont know how many people use this machine, but I got one and set it up today and began to test it so I could get acclimated, I am loading 5.5 grains of blue dot powder and everytime I cycle the machine it jerks so much that the powder spills out all over the indexing plate, now granted its...

Re: Resizing brass troubles I dont know if you trimmed the cases but they may be too long also, what caliber are you loading? Also what kind of dies?

Re: Any loads for .308 with OAL 2.95 or longer? I have loaded 178gr AMAX's to 2.995 during development, didnt work well for me so I settled at OAL of 2.886 and I get amazing results (.442" smallest, .832" largest)Regarding your question, the max I have used with varget at this length is...

Re: .308 loads not chambering? No the cases were not fired in my rifle, FL sizing, the bolt will close to just about 1/4 centimeter before the rotation knock to close it fully, the rifle is brand new, never been fired so the chamber, lugs and raceways are clean, primers are seated properly...