I’m in my idea stage of building a spray booth; if anyone has done this and can give some lessons learned it would be great.
The foot print will be about 4’ wide 30”deep 80” tall, open front
Constructed with 2x4’s and recycled paneling from a local church remodel.
I’m looking at using a 8” in-line fan rated at 500CFM
I don’t want to run an 8” hose across the shop, and then cut a 8” hole on the side of my house so I am going to taper it down to 4” I think this will cause a venturi effect but it may not be to my advantage. Right now I am planning on using a 8”diameter register box 14x6 attached to the booth (will come up with a way to attach a cheap .99 cent modified HVAC filter after the booth is built) then attach the in-line fan, then the reducers, then the 4” duct and finely a out vent with baffles to keep critters out.
The foot print will be about 4’ wide 30”deep 80” tall, open front
Constructed with 2x4’s and recycled paneling from a local church remodel.
I’m looking at using a 8” in-line fan rated at 500CFM
I don’t want to run an 8” hose across the shop, and then cut a 8” hole on the side of my house so I am going to taper it down to 4” I think this will cause a venturi effect but it may not be to my advantage. Right now I am planning on using a 8”diameter register box 14x6 attached to the booth (will come up with a way to attach a cheap .99 cent modified HVAC filter after the booth is built) then attach the in-line fan, then the reducers, then the 4” duct and finely a out vent with baffles to keep critters out.