• The Shot You’ll Never Forget Giveaway - Enter To Win A Barrel From Rifle Barrel Blanks!

    Tell us about the best or most memorable shot you’ve ever taken. Contest ends June 13th and remember: subscribe for a better chance of winning!

    Join contest Subscribe

Recent content by cwall64

  1. C

    10mm powder

    I have used Longshot, BE86, and Accurate #9 (as well as a few others). I really like Accurate #9 and BE86, but Longshot is great also.
  2. C

    Powder funnels

    Bling! I was using the see through green RCBS one for 30 years, then got board with it...
  3. C

    Powder funnels

    21st century with 10" drop tube for 6 Dasher, Extreme for the rest.
  4. C

    Shoulder won't bump but no feeding issues

    I’ll add that I had the same issue on a Forester die in the past, several folks on another forum had same issue at the same time. Seemed the dies were out of stock for a while, they became available and several reported the issue. Any other die I had (Redding, RCBS, etc) worked fine. I sent...
  5. C

    130 RDF and 130 ELD-M Velocities

    I never did any work ups on the 130 grain bullets for 6.5 Creedmoor, but the Prime Ammo loads were running mid 2900s out of a 26” barrel when I tested a few boxes. Seems it would be easy to replicate with RL16 or something slower. Sierra and Berger seem to show that also with the 130 Class...
  6. C

    Reloder Powders for 6.5 Creedmoor

    Reloder 16 has worked well for me, I have not tried 17 or 26.
  7. C

    A&D FX120i labscale reloading upgrade with V2 auto trickler review.

    This quote was from another forum:
  8. C

    So who are you using for 6 Dasher chambering?

    PVA built me a 6.5 creedmoor and a 6 dasher, both rifles shoot great when i do my part...
  9. C

    Regulator and gauge mods for Giraud annealer...edited to add volt meter...

    Thanks for the detailed video and write up!
  10. C

    Rifle Scopes Won a Burris Optics 50% off certificate....what do you you guys recommend?

    Two 5-25 XTRII scopes and they work great.
  11. C

    6.5cm & N150

    I have been using N160 for a while now with the 140 grain class of bullet (139 Scenars), 26”” barrel and normally seeing 2,775 FPS +/- 10 FPS depending on conditions...
  12. C

    ARC Mags

    Same issue with TL2 and 6.5 Creedmoor at 2.81", touch the round and it pops up. TL3 and 6 Dasher works flawlessly for me.
  13. C

    MPA Chassis Scope height question

    I am using the American Rifle Company M10 rings (34mm) in the low (24mm) configuration with a Bighorn TL3 action in a MPA Comp Chassiss. I believe they are also listed at 0.94 inches. Scope is a Burris XTR II 5x25. I did remove bridge...
  14. C

    Primer for 6.5 Creedmoor Lapua Brass

    I have tested with 136 Scenar-L and 142 SMK, somewhere in the 41.0 grain range (+/- 0.2 grains) I have found a good node. Velocity has been right under 2,800 fps. Barrel is 26 inches. I know there is most likely a higher node, but not needed for my shooting.
  15. C

    Primer for 6.5 Creedmoor Lapua Brass

    I have been using the CCI 450s and Reloder 16 just because I had a good supply. The numbers have been good, but I have not tested any other primers yet...
See more
Top Bottom
Back
Home
Forums
Merch
Alerts