Search results

I have used Longshot, BE86, and Accurate #9 (as well as a few others). I really like Accurate #9 and BE86, but Longshot is great also.

Bling! I was using the see through green RCBS one for 30 years, then got board with it...

21st century with 10" drop tube for 6 Dasher, Extreme for the rest.

I’ll add that I had the same issue on a Forester die in the past, several folks on another forum had same issue at the same time. Seemed the dies were out of stock for a while, they became available and several reported the issue. Any other die I had (Redding, RCBS, etc) worked fine. I sent...

I never did any work ups on the 130 grain bullets for 6.5 Creedmoor, but the Prime Ammo loads were running mid 2900s out of a 26” barrel when I tested a few boxes. Seems it would be easy to replicate with RL16 or something slower. Sierra and Berger seem to show that also with the 130 Class...

Reloder 16 has worked well for me, I have not tried 17 or 26.

This quote was from another forum:

PVA built me a 6.5 creedmoor and a 6 dasher, both rifles shoot great when i do my part...

Thanks for the detailed video and write up!

Two 5-25 XTRII scopes and they work great.

I have been using N160 for a while now with the 140 grain class of bullet (139 Scenars), 26”” barrel and normally seeing 2,775 FPS +/- 10 FPS depending on conditions...

Same issue with TL2 and 6.5 Creedmoor at 2.81", touch the round and it pops up. TL3 and 6 Dasher works flawlessly for me.

I am using the American Rifle Company M10 rings (34mm) in the low (24mm) configuration with a Bighorn TL3 action in a MPA Comp Chassiss. I believe they are also listed at 0.94 inches. Scope is a Burris XTR II 5x25. I did remove bridge...

I have tested with 136 Scenar-L and 142 SMK, somewhere in the 41.0 grain range (+/- 0.2 grains) I have found a good node. Velocity has been right under 2,800 fps. Barrel is 26 inches. I know there is most likely a higher node, but not needed for my shooting.

I have been using the CCI 450s and Reloder 16 just because I had a good supply. The numbers have been good, but I have not tested any other primers yet...

I have the Xtreme funnels in several calibers and have been very happy with them.

I just bought it myself after debating myself on whether to purchase or not. It came in Monday and I have been playing around with it for know loads and things that I wanted to test out, so far very glad I did.

Thanks, grabbed some powder also!

I originally bought the Giraud TriWays in 223 and 308, and they work great, but tough on the fingers when doing lots of cases! When i added a few calibers that are not offered in the TriWay I moved up to the Giraud Power Trimmer, and it is very nice and easy on the fingers! If you think you'll...

The online manual mentions sending in 3 fired and neck sized cases if you want a custom case holder.