Search results

How hard is this? Should I send it in or do it myself? I do most everything myself, but am I missing something?

So, what parts or work is required to allow running longer loaded rounds in a short action Tikka? I have a 7-08, and I would like to run overall lengths at 2.9" or so.

The stock on the Crusader is so flat the Harris spins unless tightened really tight. I know I should have gotten the rifle set up for the Atlas. So I saw the flat adaptor on the Harris site and thought I would ask.....

I had worked up a decent 7mm-08 load with the subject powder, from a pound I had purchased about a year ago, and recently purchased 3 more pounds. I loaded up three rounds with the new lot and the "good recipe" and today they chrono'd almost 100fps slower. Anyone else experience this with...

Thanks.

Do folks use just the standard, 210M, or the 215M?

Has anyone worked with this and 150 grain bullets?

Does anyone have experience with the Lumley Arms bolt shrouds and recoil lugs? Thoughts?

Well, now that NF has the Beast and the 2.5-10 X 42 out there, I think they need to get after releasing a 1-6 or 1-8. NF, FYI, I am not above begging......

I have been looking at trying either AR Comp or 2000MR for my 20" LMT with a 175 Sierra. Any preferences?

After 21 years of really good service, I have come to the conclusion it is time to replace my Dewalt cordless drill/driver. What is the best one out there from a reliability, power and battery life standpoint? Thanks

Is there a good ballistics ap for the iPhone 4s?

Anyone tried one yet?

When I first saw this rifle, I thought that it was exactly what I had been wanting to build as a general purpose rifle. Anyone have one, and what are your thoughts, besides "it's a GAP!" (which is inherently goodness).

Does a upper receiver vise block for a DPMS fit the LMT/KAC uppers? Brownells sells one for the DPMS.

Is the subject pack smaller in height than the Eagle pack, that is, would it fit on a smaller, more compact stock that is too small for the Eagle? thx

How does the reset point on the LEM differ from the traditional DA, if at all? thanks

Any experience with these out there?

who has these dies in stock?

I was looking an R8 over at a fun shop and was about to buy, when I noticed some peening of the frame over the firing pin where the hammer stops. Is that normal? I am a little concerned about the Aluminum framed guns, and this kind of gave me the willies. Thoughts?