seekins

I've left word for Glenn at his shop, but was wondering if the .308 mag system has the same "footprint" as the .223 mag system? In other words, If I have a manners stock inlet for the .308 mag system, but want to change the rifle to a .223ai, will the Seekins 223 mag system work?

I have an SPS tactical 308 and am getting a Zeiss 3-12x56 for it. I'm using an IOR 1 piece base and want to use Seekins rings. I want to mount the scope as low as I can, so what height will I need?

Wanted to get a couple of opinions before I make a purchase. I bought a 5 lug 25moa base from Richard Near for my TRG-42 and he also sent me his Alphmount to check out at no cost(outstanding customer service). Scope of choice is a USO SN3 3.2-17x44 with 35mm tube. I don't have the scope yet and...

Does Seekins still sell the 6 screw/4 screw combo ring set? Early last year I topped a .308 KMW with a combination set where the 6 screw was forward and the 4 screw aft of the elevation adjustment. This setup rocked and I'm hoping I can replicate that on an upcoming 260 AI rifle topped with...

so what are some bases that the seekins rings work well with? will they fit the us optics base? I have a PRI base that seems to be just a bit too wide for them. Any recommendations? looking at 0 MOA bases. thanks

can anyone post a picture showing seekins rings mounted where the side of the rings with the screws is visible? up close? Whenever I mount my rings the little piece on the rings to secure it to the base is somewhat canted. is this normal? thanks

Can you post pics of Seekins rings and S&B 3-12X50. Thanks

just got a pair of 4 screw seekins rings. I CANNOT easily rotate my us optics sn3 in them without scratching the scope body. Has anyone lapped their rings before?

Hey Glenn, I got a set of your three screw 30mm rings way back when you first started making them & just got around to putting them on a rifle. Would you mind gving me the torque specs again?? THANKS!

Mounting a Leupold Mark 4 4.5-14x40 on a Remington 700 SPS Tactical with a EGW 20moa base. I am guessing the Seekins low rings will be the ones I want. Can someone verify that for me. And is there a preference between the 4 screw and 6 screw?

How do Seekins bases measure up to others, ie Badger, Near..?

Wheres the best place to get Seekins rings and bases the quickest? Direct from Glen?

We have been busting butt here this last week getting ready for SHOT and thought we would show what you are going to miss. I am excited to present Billet SP-223’s  They are 7075, hard anodized and 100% machined out of plate. The nice large mag well area makes inserting a mag about as...