I'll have to fap for an hour.

Ok guys …. Listing up more extra parts to further other builds! NO TRADES NEEDED! Payment by PayPal f&f only! Shipping is included in my prices. But, if you want insurance? It’s on your dime!

Since these forums are getting flooded with piece of shit scammers? Please do not post an I’ll take it in the thread!

I’ll be adding items as I find them. So check back as I dig them out please.
Arken optics 4-16x50 sh4 gen ii moa vpr reticle. 34mm tube ffp illuminated etc….. scope is new! Only took out for a mock up. 250.00

Badger ordnance 20moa rail for a Remington short action 110.00

Badger ord 34mm 1” height m40a3 rings. Rings are used! Biggest caveat is that the 6 screw rings,the middle screws where stripped out. Had to use a dreamer to cut them loose on one side. So,they’re missing two screws in the middle. And the one I cut is still lodged in the hole. Rings still function as they are! But my price reflects the fact that they aren’t perfect. 100.00 shipped

Ar-15 parts lot….. there’s a complete mil spec trigger(less trigger pins). A new a2 grip with the mounting screw,two winter trigger guards with hardware. And a 20moa riser mount. 40.00

Just pick up a bushy lrtsi 3-12 for a gas guns.
read some good reviews here.
Any pics with this optics on yours rigs? Also if you have any negative or positive experiences , be glad to read them too.

Is it feasible to switch a scope back and forth between rifles? Specifically I'm wondering about doing it between a rimfire and centerfire rifle, as I have more opportunity to shoot the small gun. Technically it sounds ok in my brain but in actual use it just seems like a bad idea.

The average monthly mortgage payment in Joe Biden’s America has soared to $3,322, per analysis from the Wall Street Journal.


That $3,322 is nearly double the average monthly mortgage payment when His Fraudulency assumed office. When former President Trump left office, the average monthly mortgage payment was $1,787.

WSJ analysis of the housing market:
Average monthly new home payment
when Biden took office: $1,787
Average monthly new home payment
today: $3,322 pic.twitter.com/OBqjAM9Hr3
— Tom Bevan (@TomBevanRCP) December 11, 2023

Click to expand...

“Homeownership has become a pipe dream for more Americans,” writes the WSJ, “even those who could afford to buy just a few years ago.”
“Many would-be buyers were already feeling stretched thin by home prices that shot quickly higher in the pandemic, but at least mortgage rates were low,” the report adds. “Now that they are high, many people are just giving up.”
But let’s remember who these people are who are looking to enter the housing market — young people. And who do young people vote for overwhelmingly? Democrats. And so, allow me to welcome you to today’s edition of People Getting What They Vote For:

It is now less affordable than any time in recent history to buy a home, and the math isn’t changing any time soon. Home prices aren’t expected to go back to prepandemic levels. The Federal Reserve, which started raising rates aggressively early last year to curb inflation, hasn’t shown much interest in cutting them. Mortgage rates slipped to about 7% last week, the lowest in several months, but they are still more than double what they were two years ago.

Click to expand...

This is good news for me. The wife and I purchased our home in 1997. Afterward, we worked hard and saved harder to pay it off by 2003. Ever since we’ve been saving our money for retirement, and now that we are Of A Certain Age where it’s no longer wise to try to ride out stock market downturns, we have taken advantage of these gloriously high interest rates Democrats voted for. Our money is now nice and safe and snug in an interest-bearing account working its butt off for us. Thanks, Unhoused Zoomers!

Good move every one hated the Sig 229 when they replaced the M9 with it , qualification scores went down due to the horrible trigger

The round in question was 7.62x54R. You folk know I like old things.

I don't really give loads on the internet but lets say it was on the softer side and was using a well respected powder, and a load I had been using FOREVER. Reason I am being shy around the powder is here at work I am not sure I remember correctly, N130 or N150. I just don't remember off the top of my head.

I had a few weeks off, that was nice, and one of the things on the table was doin some shootin. So I did. I got quite a few things dirty, some things I had not shot in decades. Made me really ask myself, why don't you do this more often, it is kind of fun. More on that in another thread.

But the rounds are loaded in 2022, stored in the "usual" little plastic box of your color choice, in a cabinet in the basement. Just like every other one in that same box.

This happened with about 6 rounds left in the box, and really made me think for a sec if I wanted to finish out the box. I stopped short, and still not sure if I will pull the others down. Looking on views on that. 45 rounds-ish in that box shot just fine, but this one, not so much.

Click no bang....hmm. Give it a few sec, then open up the gun 91/30 sniper wanna be. I got it from SOG years ago at the height of the "fake sniper" craze. Everyone wanted to play Enemy at the Gates, and why not. Cheap rifle and Rachel Weisz, nice butt.

I had a pic of the card, but will blurr out the info.




You likely know the card, but a few things, the 2.791 is COAL, and primer is "old" CCI primers I had laying around in reserve...nothing special, just old packaging I got at a gun show. At the time LRP are still a bit hard to find.

A couple photos of the powder, you can tell something happened somewhere. I just found it odd.

And yes I crimp the ever living hell out of them, those old soviet automatics, SVT-40 and PSL are just a tad rough. The bullets and loading are light as the SVT is not the strongest design out there. Get too heavy a bullet or too "hot" a load and the gun will basically bend the back of the rec. So light loads are what is called for and light bullets. They both shoot these just fine, but drop is pretty quick.





I have had this "basic" thing happen twice now. First one was when I put a 38 up for storage loaded when I went in for my first surgery. I had it "covered" with Ballistol as I was not sure when/if I was going to recover from some surgery. About a year later I grab it, open it up, looks fine, clean it up a little lint, dog hair, general dust, and down I go.

Round 1 ok, round 2 sounded a bit soft, round 3 phfsssstttt. Full stop. I was able to open the gun up so at least the bullet made it all the way into the barrel, and back up to the house I go.

I pull the rest of them down, One looked ok, two looked ok, three looked like tar. And again yes I crimped. The ballistol must have got in there some how, around the crimp or the primer pocket are the only choices. The other day above was dry as a bone, but the 30 was wet and goopy.

Had to drill out the bullet from the nose of the revolver.

Wanted to give you guys a heads-up that EuroOptic and 3 other dealer are getting these scopes, EuroOptic will have the most scopes in inventory with 140 of each type. I'm not sure how many of these scope will be made, but the current estimate is 300 of each type, which will be split between the 4 dealers. I have no affiliation with EuroOptic, I'm just letting fellow clone builders and collectors know about this deal. An email should be going out later today, you can call them to order the scopes right now since they haven't been uploaded to their website yet.

The 2 NightForce Mil-Spec scopes are:

1-8x24, SU-294/VPS S-VPS

7-35x56, SU-296/PVS P-VPS

I have no idea if they'll get the 4-20x50 Mil-Spec scope, maybe that will arrive next year, but I have no idea.

I know it's on to the next level of BS, maybe a win on the State Supreme Court can be had. Don't think it can't happen to you.

Tcs with steel rail, has some weights

$1600 shipped and insured

I am looking for a Rancher or Indian guide in South Dakota to shoot some prairie dogs. If anyone has a contact they would like to share I would appreciate it. Pm me if possible. Thanks Codie

So, going through some stuff that was my Uncle. He was big bringing Nightforce to the US and helped out in the early days. He passed a few years ago and I’m just starting to go through his thing. Found this cool old scope. Anyone ever seen these before?

New here registered because i found a rifle in my local walmart parking. Doing all i can to find its owner before i turn it in to the local pd

I have a gen2 super trickler for sale. In perfect condition and runs n140, h4350 and cfe223 well. Firmware 2.20 is installed and seems to be working the best. $650 shipped in the continental US.

33 PRC? when will it be announced? It only seems logical with the success of the PRC family that the 33 PRC will come out soon. What are your predictions? Maybe just a necked up 300 PRC is fine with me. Any thoughts are appreciated

https://www.snipershide.com/shooting/members/sneakypayioad.216681/ or @sneakypayIoad

Because of the type used on this website, an i looks like an l for usernames, this is bad admins.

The members URL and it's limited. Please be careful out there guys, he got someone tonight.

@admins, ya'll need to do some housekeeping on how profiles are made, created, and posting is done. This is security 101. Fonts on the webpage shouldn't be hard to distinguish, or whatever the default font is.

For anyone out there attempting to BST. Try to only deal with members that have some feedback, don't give money to day 1 accounts, and verify who you're talking to. if they aren't willing to talk to you on the phone for an item that costs a bunch of money, whether it's 100 bucks, or 1k, pass on the sale.

Up For Sale is Manner molded Gap Camo REM 700 footprint,with Black REM BLD, comes with action Screws. Pillar and Devon steel bedded, opened up to receive a Bartlien M40 contour. 3 flush caps. 2 swivels studs. Barreled action sold now stock is up for grabs. $500.00

Benelli m4 and glock 19 Sold!

Daniel Defense withdrawn and sold to local buddy.

Appreciate you looking.

**SOLD**
RARE OPPORTUNITY to own a like-new AIAX ELR. Selling for a buddy who’s life has recently been turned upside down. Rifle is basically brand new. No dings, no scratches. Fired 20 times. Comes with original box, paperwork, and fitted hardcase. Bipod not included. Specs:

• 50 BMG
• 27" barrel
• 1 - 15" Twist
• Thread Pitch - M24x1
• 45 MOA rail & 12.5" forend rail
• Two-stage trigger, 3.3-4.4 lbs
• One 10-round double stack mag
• Quick adjust butt and cheek piece
• Right folding stock
• AI muzzle brake
• Weight - 27 lbs.
• Length, Extended - 54"
• Length, Folded - 45"

$12,750 shipped and insured.

I’ve been around the Hide a long time. Read my reviews. Deal with confidence.

Pair of Remington 700 short actions. Prices include shipping. Your FFL must receive from a private party (or add $35 for the transfer fee my FFL charges). PayPal F&F, Zelle, or USPS MO.

1. (Top) Parkerized C series action from a 700p. Previously painted, good condition overall. 308 bolt face, comes with Walker trigger and recoil lug. $450 shipped SPF

2. (Bottom) Blued C series action. 308 bolt face, comes with recoil lug. $450 shipped.

Milwaukee police shooting, jury awards man $2M: 'Couldn't ...​

FOX6 News Milwaukee
https://www.fox6now.com › news › 2014-milwaukee-po...

Looking to see what transferable machine guns are out there for sale

browning m2 is at the top of the list

But let me know what you have

can never guess what they will do. sometimes pro 2A,sometimes anti. sometimes pro commie,sometimes anti. BTW,i mean communism as a form of fascism. maybe their position has to do with who is running their show at any given time? to me very unpredictable what they will support.